 |
Transmitter with a contact free, capacitive sensor system for the acquisition of the angular position of a shaft. The output is a load-independent DC current signal of 4...20 mA proportional to the measured value.
- Patented contact free capacitive sensor system
- Measuring range, direction of rotation, characteristic, switching point and other additional functions programmed using PC / Simplifies project planning and engineering, short delivery times, low stocks
- Measuring range of angle of rotation: 0...10 to 0...50 or 0...50 to 0...350°
- Measuring output (output/powering circuit) in two-wire connection (4...20 mA signal)
- Very low torque (< 0.001 Ncm, with 2 mm shaft)
Advantage: The shaft can be rotated practically without any reaction effects and is therefore not a «load» on the connected devices.
- Compact size, only 48 mm Æ
Advantage: it can be installed anywhere (OEM)
- Type of protection “Intrinsically safe” EEx ia IIC T6 / Can be mounted within the hazardous area
- Simulation of measured values / The testing of the subsequent device chain is already possible during the installation phase
- Measured value acquisition / Display of the instantaneous value and a trend graph of the measured value on the screen
- Adjustment / Independent fine adjustment of the analog output, zero position and measuring range
- Characteristic of the output value / Programmable as a linear, V-characteristic, or any characteristic curve
- The shaft can be turned through a full 360°
- Serial interface
| Article No. |
mechanical
Angle
Range |
Meas.
Range |
Reversing
point |
Direction of
Rotation |
Output
Characteristic |
| 760-1111100 |
50° |
0.. 50° |
55° |
Clockwise |
Linear |
| 760-1211100 |
350° |
0..350° |
355° |
Clockwise |
Linear |
Order other variants with complete order code 760-.... in
accordance with the data sheet.
|
